Wireless headset mod v1 
Hello everyone, I got my headset mod ready few days ago (finally) and here's kind of a report of the process.

It all started with this Logitech Clearchat Wireless headset:Few years old headset, casing and frame was crumbling apart.

This headset, also known for a design mistake which causes the left headphone to cut and eventually go silent (it's just wire wearing and getting cut, see this), is quite good in terms of audio quality. So it would have been shame to throw it away, despite it was already old and I could've afford a new pair (from some other manufacturer). Since I had already opened it up a few times fixing the cutting left phone I had some kind of idea what was inside, so I decided I'd find some cheap wired headset and put the electronics from the old one inside the new pair. Time flew and I just couldn't find suitable headset, until I looked at the Peltors below on another occasion. They were soundproof, had lot of space inside and were relatively cheap.

Peltor ear protection set disassembled.So the project started slowly to proceed. I had already most of the tools:

Soldering iron
Drill with grinding heads
Small vise
Various screwdrivers

And that was about it. Some small stuff like wires, connectors and glue was also needed.

Here's some pictures of the old headset being opened up:

The PCB is pretty dense on components and since you only have the silkscreen markings it's quite a pain to figure what goes where, since it's a 4-layer board. I just used a multimeter to find out how the 8-pin connector (on top, white block) connects to some places which are easier to solder without fear of short-circuits. the other side of the board there was number of test points, labeled "TP#", and most of the connectors pins were connected to one of the test points.The right headphone side is much simpler, since there is basically no electronic components there, just wires connecting.

The ear protector cups had two layers, which was a challenge but also a boon, since I could attach buttons and connectors to the inner layer so they are firmly there and don't give in when trying to push the connectors together. I modified the ear cups by drilling holes for wires and buttons and connectors like below:

So, after testing out the correct connections, I replaced the flat connector with a general pin header with individual wires soldered and twisted around each other. Unfortunately, the microphone stopped working for some reason, I might have connected some voltage inversed to the mic which broke it. I gave up on it, since it was rather impossible to debug it without an oscilloscope. So I put the rest together, and got rather nice wireless headphones instead of a headset.During the process I learned much about what should be taken into account when designing how to fit electronics into their casing. I made a lot of mistakes and hopefully won't make them next time. I'm thinking about making my own electronics for version two, using bluetooth or something as wireless solution, maybe trying to fit it into something smaller than these Peltors.

If you want any details just ask for them, I might make a more detailed post later too, about the wiring and such.

[ add comment ] ( 13381 views )   |  permalink  |  print article  |   ( 2.9 / 608 )

<Back | 1 | 2 | 3 | Next> Last>>